FREE UK MAINLAND DELIVERY ON ORDERS OVER £50
Not Find Exactly What You Need?
Advance Search
Not Find Exactly What You Need?
Advance Search
The bore and outside diameter of SKF Y-bearings are produced to tolerances indicated in the table. Symbols used are explained in the following. The values specified there for bearings in the
Bearings in the YSA 2 K series are manufactured with a tapered bore, taper 1:12. The tolerances for the tapered bore can be found in the table. The hexagonal or square bore of bearings in the YHB 2, YHC 2 and YQC 2 series is produced to tolerance 0/+0,25 mm.
Symbols d = nominal bore diameter
?dmp = deviation of the mean bore diameter from the nominal
D = nominal outside diameter
?Dmp = deviation of the mean outside diameter from the nominal
Terminology | Y-bearings with grub screw locking | Y-bearings with an eccentric locking collar | Y-bearings with a tapered bore | Y-bearings with a standard inner ring | Y-bearings with a hexagonal or square bore | Special design bearings | Seals | Dimensions | Tolerances | Radial internal clearance | Cages | Grease fill | Speeds | Shaft tolerances | Rubber seat rings | Axial load carrying ability | Equivalent bearing load | Mounting and dismounting | Designations
All trademarks, logos and brand names used on this website are the property of their respective owners. All company, product and service names used in this website are for identification purposes only. Use of these names, trademarks and brands does not imply endorsement.
bearingswebshop.com is a trading name of 1T Solutions Limited bearingswebshop.com
© 2008 – 2025 1T Solutions Limited. All Rights Reserved.
Disclaimer:
Errors and Omissions Excepted.
Any dimensions, tolerances or performance figures shown on this website and any associated documents are for guidance only. For factual figures, reference should be made to the current edition of the appropriate standards where applicable.
Every effort is made to keep the information on this website accurate and up to date. However, bearingswebshop.com accepts no responsibility for errors or omissions or for any third party loss or consequences arising from what is published.
The information within this website is based on our present knowledge and experience, and is supplied in good faith.
No liability is accepted by bearingswebshop.com. in respect of any action taken by a third party.
The products detailed on this website may be used for a variety of purposes and as bearingswebshop.com has no control over their use. bearingswebshop.com excludes all conditions and warranties expressed or implied by statue or otherwise, as to dimensions, properties and/or their suitability for an application.
